2018年10月26日星期五

What problems do you need to know about flour mill equipment?

Abnormal condition happens in flour milling machinery and flour mill equipment are inevitable, so as in any machinery. However, if you understand the working principle of flour making machine, you can effectively improve the work efficiency and reduce bad influence on flour making machine.

What problems do you need to know about flour mill equipment?

  • The failure of spiral stirrer. This may caused by excessive feeding, incorrect motor rotating, blocked discharge ports, broken blades of the stirrer, etc. Related technicians need to check carefully to find out the reasons and then solve them.
  • The failure of air lock. Due to poor ventilation, the bag may be sucked up. Common causes include leakage at the joint, wear of the impeller, etc. In the latter case, a rubber plate can be installed on the outer edge to improve the condition.
Airlcok in flour milling plant
  • The failure of motor. Under normal circumstances, flour mill equipment need to use more than 10 different sizes of motors. Therefore, if something goes wrong, it must be checked in time to avoid potential safety hazards. The cause may be bearing oil shortage, damage or overload of motor.
  • The freshly processed flour is wet. Some people may mistakenly think that there is a mechanical problem. But it is not. As I told you that in the flour processing process, cleaning is an essential process, which is mainly used to remove impurities and facilitate wheat peeling. So it's normal to have some moisture. If you want it to be drier, we has have direr to make it dry.

Maintenance of flour milling machinery

The maintenance of the flour mill equipment will greatly help the service life of the flour milling plant and single flour making machine. Therefore, in the daily processing and production, we must regularly maintain the flour mill equipment. Let's take a look at how to do the maintenance of the flour mill equipment!
  • In order to avoid some erroneous operations of personnel, resulting in equipment failure, affecting efficiency and shortening the service life, as a regular manufacturer, it is required to ensure its flour mill equipment operators to be proficient in corresponding laws, regulations and management systems, and obtain professional qualification certificates or certificates. Qualified for training to operate, this can greatly reduce the failure rate.
  • For routine maintenance, personnel should pay attention to the fact that some special parts of flour mill equipment. Such as glass instruments should be kept clean and dry and classified and stored. At the same time, direct heating of glass instruments should be avoided, and the correct practice is to use asbestos webs to heat slowly and uniformly.
Check-the-flour-mill-machinery

In short, there are many factors that can affect the equipment during use, such as dust, temperature, humidity, vibration, noise, corrosion, etc., personnel should pay attention to strict control to ensure that flour making machines work table is fixed and flat, and meet the requirements of use. After use of the flour milling machinery, clean up and restore in time. In addition, the power equipment should be installed with an independent power switch in accordance with the rated power, and have a good grounding wire and a regulated power supply.
Correct using and proper maintain are two main aspect that influence the service life of flour mill equipment, also the best way to reduce the cost of fixing or replace a new flour mill machinery. To lowest the cost and get the biggest profit, as a flour plant owner, the above two aspects are basic knowledge for you.
As for these who are planning to start a flour bossiness, it is a good choice for you to visit our website to get some necessary information you need. If you have any question, please do not hesitate to contact us.   F